![]() Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. John Deere and its logos are the registered trademarks of the John Deere Corporation. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. websites are the property of their respective trademark holders. products and within the Yesterday's Tractor Co. TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. ![]() Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Ĭopyright © 1997-2019 Yesterday's Tractor Co.Īll Rights Reserved. Our fast shipping, low prices and years of research make us your best choice when you need parts. Cushman Cub or Hercules JI JK Mag Drive & Return Spring Set Gas Engine Motor ship same-day on orders before 3 p.m. We have the parts you need to repair your tractor - the right parts. I have a number of parts / wrecked engines etc (stored near Whitehorse).įast Shipping! Most of our stocked parts ship within 24 hours (M-Th). I got my Witte's (AD & BD) from the same place as you. A small spring has to be installed on the opposite end of the rack. The operating chain is to be attached to the fuel injector pump rack. This should provide enough speed for the sensor to work. CUSHMAN CUB SERIAL NUMBERS INSTALLBeing most cruise controls require a speed of 25 to 35 mph in a vehicle to work, I am going to install a sensor target on the small dc generator pulley, which is driven by the cooling fan belt. I propose to tap into the crankcase for suction using a check valve and vacuum pressure cannister in the system to operate the cylinder. I am going to install a cruise control module and vacuum cylinder available from J.C. I have not tried this yet but I think it is feasable. If you check around with some of the oil well engine overhaul companies down in Oklahoma, you can find an original head gasket but you should use the crush washer with it.Īnother comment is the Witte CD engine governor does not do well at holding cycles steady. The only draw back, minor, is it is thicker which lowers the compression ratio a little. It does not have a fire ring because it can withstand the temperature and pressure. This is not needed with the graphoil gasket.Īrrow engine sells the new style gasket, Graphite/oil. It is not readily available, but with some searching it can be found. It was installed in the recess in the head and the cylinder sleeve sealed against it. There was also a crush washer seal used with this gasket. ![]() The orginal head gasket was manufactured from asbestos and copper composition. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |